RETAINING COMPOUND
SKU:
$49.50
$49.50
per item
RETAINING COMPOUNDS
SEALXPERT RC603 RETAINING COMPOUNDS
FEATURES:
- High strength, low viscosity
- Good oil tolerance, can be used on surfaces with slight oil contamination
APPLICATION:
- Seals and secures cylindrical assemblies under 0.005” (0.13 mm ) diametrical clearance
- Designed for transition and interference fit
- Used for slightly oily surface and inert surface
SEALXPERT RC603 RETAINING COMPOUNDS
PACKAGE:
- 50 ml / bottle
SEALXPERT RC620 RETAINING COMPOUNDS
FEATURES:
- Thixotropic viscosity
- Self-curing high temperature resistant
APPLICATION:
- Designed to retain cylindrical fittings which can endure high temperatures 232 °C (450 °F)
- Generally applicable for parts whose working temperature is 150 °C (302 °F) to 230°C (446 °F) (intermittent and continuous)
- Used to bond and retain automobile air valve sleeve, injection molding machine core sleeve, valve bushing, cylinder liner, plunger pin in steam hammer; seal or lock thread
SEALXPERT RC620 RETAINING COMPOUNDS
PACKAGE:
- 50 ml / bottle
SEALXPERT RC638 RETAINING COMPOUNDS
FEATURES:
- Maximum high strength, high viscosity
- Fixture in 5 minutes
APPLICATION:
- Used for retaining cylindrical assembly where fit clearance can approach 0.01” (0.26 mm) and where maximum strength at room temperature is required
- Lock bushings and sleeves into housings and on shafts
- Designed for transition and interference fit
SEALXPERT RC638 RETAINING COMPOUNDS
PACKAGE:
- 50 ml / bottle
SEALXPERT RC648 RETAINING COMPOUNDS
FEATURES:
- High strength, medium to low viscosity
- Withstand high temperature to 175 °C (347 °F)
- Fixture in 5 minutes
APPLICATION:
- Used for dynamic loading or periodic loading working conditions
- High temperature resistant, cures fast, retaining cylindrical assembly where fit clearance is less than 0.006” (0.15 mm)
- Designed for transition and interference fit
SEALXPERT RC648 RETAINING COMPOUNDS
PACKAGE:
- 50 ml / bottle
SEALXPERT RC680 RETAINING COMPOUNDS
FEATURES:
- High strength, medium viscosity
- Enhances bonding strength
APPLICATION:
- Used for diametral clearance of less than 0.01” (0.25 mm) clearance fit or transition fit with the best fit clearance between 0.002” (0.05 mm) to 0.004” (0.10 mm)
- Replace press fit and prevent rust
- Used for slight rotating (worn) bearing, shaft sleeve etc. fittings, retain belt pulley, bushing, gear wheel, rotor, rebuild hole-shaft fitting parts and out-of-tolerance parts
- Designed for transition and interference fit.